Home / Products / Bimetallic vs Chromium Carbide vs White Iron
Wear Parts

Bimetallic vs Chromium Carbide vs White Iron Wear Plates

Three families, three failure modes. How to choose the wear plate for a chute, hopper or transfer point.

The three families in one page

Bimetallic plates, chromium carbide overlay (CCO) plates and white iron wear plates are often quoted against each other for the same chute. They are not interchangeable: each fails in a different way, and the failure you had last time is the best guide to the next order. For the first family, see the bimetallic wear plates (BT-CW) page.

How each one is made

Bimetallic plateTwo solid metals bonded into one plate: a hard wear layer on a structural steel backing. The plate can be cut, formed, drilled and bolted.
Chromium carbide overlayA carbide-rich layer welded onto mild steel. The hard phase sits in a weld deposit, so the surface is extremely abrasion-resistant but less tolerant of impact and tight forming.
White ironHigh-chrome white iron, cast or laminated onto a backing. Very hard carbides; brittle. Supplied as blocks, tiles or laminated plates rather than a drilled sheet.

Where each one wins - and how it fails

BimetallicWins: sliding abrasion with moderate impact, formed and drilled liners, replaceable bolted plates.
Fails when: the wear layer is too thin for the interval, or the backing is allowed to wear through after the face is gone.
Chromium carbide overlayWins: pure sliding abrasion, high tonnage, flat or gently curved surfaces.
Fails when: it takes direct impact, is formed tightly, or is cut and welded badly - the overlay can crack and spall.
White ironWins: severe abrasion at low impact, block and tile layouts, very high wear rates.
Fails when: lumps strike it, the backing flexes, or it is bolted through thin sections - it chips and cracks.

Five questions that decide it

A practical lining pattern

Most chutes we quote are mixed. Bimetallic plates cover the walls, the transition and the bolt-on zones. Chromium carbide overlay, where the customer already standardises on it, goes on the long sliding floor. White iron tiles sit at the direct impact point under the feed. That pattern spends the hardness where it is needed and keeps the rest of the chute serviceable.

If you are replacing a liner that failed early, send a photo of the failure with the drawing. The wear pattern usually settles the material question faster than a specification table.

Where our plates fit

We make bimetallic wear plates and explosion-welded compound steel plates, and we supply tool steel clad wear plates for mill housing liners and precision flat guides. For chromium carbide overlay and cast white iron we will tell you when they are the better buy instead of substituting quietly.

FAQ

Related reading

More on wear plate selection

Bimetallic wear plate manufacturer in China · Wear plates for chutes and hoppers · Compound steel wear plates

Need a quote or a custom part?

Send your drawing, sample photo or specification - we reply within 1 business day.

Request a Quote