What we make
We are a wear-parts manufacturer in Shenyang, China. Our work is split between cast and machined bearing alloys and fabricated wear plate: bimetallic (BT-CW) wear plates, explosion-welded compound steel plates and copper-steel bimetal clad plates, cut and drilled to drawing.
Buyers usually come to us for one of two reasons: a drawing that a trading company cannot answer, or a liner that failed early and needs the duty looked at rather than a like-for-like replacement.
What a manufacturer can answer that a trader cannot
| Build-up | Whether the wear layer and backing you specified will survive the duty, and what the section does to forming and drilling. |
| Fixing | Whether a countersunk hole leaves enough backing, and where a plug weld will sit relative to the wear layer. |
| Flatness | What the plate will do when it is bolted down, and where it needs stress relief or a formed section instead of a flat one. |
| Substitution | Whether a named grade can be replaced, and the specific property that changes if it is. |
How a quote is built
- Drawing review. Outline, thickness, build-up, holes, countersinks, keyways, forming and quantity are read together, because each changes the other.
- Duty check. Material, lump size, drop height, temperature and the failure pattern of the old liner.
- Process route. Cut, form, drill, stress relief where needed, hardness test, mark and pack.
- Quote. Price, lead time and the assumptions written down - so the order does not change after the PO.
Quality checks on every batch
- Wear-face hardness tested plate by plate with a Leeb tester; reading marked on the piece.
- Outline, hole pattern and countersink checked against the drawing before packing.
- Flatness checked so the plate seats without shimming.
- Test records and packing list supplied with the delivery documents, traceable to the plate.
Packing and shipping
Plates are stacked with edge protection and banded so machined faces and countersinks arrive undamaged. Small sets are crated; large plates are palletised or bundled to the freight forwarder's specification. We ship from Shenyang and can quote FOB, CIF or delivered terms; tell us the destination port and the on-site date you need.
What to send
- Drawing (PDF or DXF) or a dimensioned photo of the worn plate.
- Duty: material, lump size, drop height, wet or dry, temperature.
- Quantity, required on-site date and destination port.
- Any standard the plate must meet, and whether a test certificate is required.
FAQ
- Are you a manufacturer or a trading company? A manufacturer. Casting, machining and plate fabrication run in our own workshop in Shenyang, Liaoning. Wear plates are cut, formed, drilled and hardness-tested in-house, and enquiries are answered by the people who quote the drawing.
- What is the minimum order quantity? There is no fixed catalogue MOQ. The quantity that makes sense depends on plate size, nesting and material - a single large plate can be economic, and small plates are usually grouped. Send the drawing and quantity and we confirm.
- How do you quote a wear plate? From the drawing: outline, total thickness and build-up, hole pattern, countersinks, keyways, quantity and any forming. If the drawing is incomplete we ask for the duty and the old plate rather than guess.
- Can you work from a sample instead of a drawing? Yes. Send the worn plate or a dimensioned photo; we measure it, produce the outline and confirm the hole pattern before cutting.
- How are plates packed for export? Plates are stacked with edge protection, banded, and packed so machined faces and countersinks are not damaged in transit. Packing list and test records go with the shipment; export documents follow the terms on the order.
- What lead time should I plan for? Typically 7-20 days from drawing approval, depending on size, quantity and fixing detail. Sea freight adds transit time; tell us the required on-site date and we quote against it.
Related